Wel this is my third tut since i've begon..yesterday :lol:
With this tut you can learn how to import a .mov (a quicktime movie) into your sig.
Hope you like it..

I'm using this sig (400x200):




#1

Ok lets start with opening your sig in Adobe Imageready. Let it as it is and open your .mov file File>Open>Yourmovie.mov



I used the setting select range only because i don't want to have the whole movie on my sig (the size would me to large). Hold shift and select your piece of movie you want to add in your sig. Press ok.


#2

Play your movie in internet explorer (Ctrl+Alt+P) if your movie goes to slow you have to edit the delay (I used 0,03)




#3

Now go to Image>Canvas Size and set it to the size of your sig (mine is 400x200).




#4

Now you have to put your sig onder all your movie layer. Just grab it and pull it to your movie sig like this:




#5

My movie is to large to put it in my sig so i have to make it a bit smaller. Press the first layer on your pallet, hold shift and press the upper layer so they are all selected.



Now press Ctrl+T. Hold shift and make it smaller until you're satisfied with the size.




#6

Now you will see that your sig isn't in the center of you canvas. Just select your sig layer and select all of your animation layers (click on the first animation layer, hold shift and press the last one) like this:



Now just place your sig where you want it




#7

Now you're done!

My final result:



Don't hold back, post your result here and if you like it.. register :lol: